Why won't my riding mower start?
If the engine in your riding mower won't stop when the key is turned to off, or the engine won't start when the key is turned to on , the most likely problem is the ignition switch. The instructions for this easy repair are in our DIY repair Guide How to replace a riding lawn mower ignition switch.
What is an ignition coil?
An ignition coil, sometimes called a spark coil, produces the energy needed for the spark at the spark plug. Our DIY repair guide How to replace a riding lawn mower ignition coil gives easy-to-follow instructions for this quick and easy repair.
Where to put plastic beading on a car seat?
Set the plastic beading into place at the center point of the seat bottom. Set one edge of the beading on the vinyl of the seat front, the fold on the edge of the seat and the other side of the beading over the vinyl on the back of the seat. The foam should not be inside the beading. The tight fit will keep the beading in place.
How to make a vinyl seat?
Start at the center point on the bottom of the seat and spray glue to the foam and frame of the seat and to the back of the vinyl. Wait two minutes then press the two surfaces together, pulling the vinyl taut as you do so.
How to keep vinyl beading in place?
Securing the beading will tuck the vinyl under the edge of the seat frame. Stop when you come to the corner. The tight fit will keep the beading in place.
Where is Dee Em?
She has earned a degree from the New Liskeard College of Agricultural Technology and is working on her Associate of Arts with the College of New Caledonia.
Remove Debris, Wash and Dry Riding Mower
Brush large collections of grass and debris from the mower. Use a garden hose to spray off the lawn mower to remove dirt from the mower. Be careful if you choose to use a pressure washer. You should not use high pressure near the riding mower’s bearings. Even though bearings are often sealed, they are not sealed from high pressure.
Scrape Your Riding Mower Deck
Prop your mower deck up by using jack stands or another comparable item. Be careful using pneumatic stands as they can shift and put you in a very dangerous position. If you are unable to get enough height to reach under your mower deck you may need to remove the deck from the lawn tractor. Refer to your owner’s manual for instructions
Add Fuel Stabilizer or Drain Your Fuel Tank
While many riding lawn mower owners choose to drain their fuel tanks for storage during the winter season, I choose an easier option and add fuel stabilizer to the existing gas. Either option is okay. Leaving untreated fuel sitting in your lawn mower over the winter can cause problems with the fuel system.
Remove the Battery and Clean Terminals
You also have an option when it comes to storing your battery during the winter. When your battery is fully charged, it will not freeze. If you choose to keep the battery installed on your riding mower, you must make sure it is fully charged.
Use a Rodent Prevention Method Around Your Riding Mower
Too many times in my position at the independent lawn mower and tractor dealership I worked at, I saw the damage rodents can do to a piece of equipment. Sometimes the dead rodents are still in the filter housing, radiator, or tangled in wiring harness when the equipment is brought into the repair shop.
Store Riding Lawn Mower in a Dry Cool Place
Your riding mower should be stored in a cool dry place. Cover your mower with a tarp or large drop cloth to keep the dust off the lawn mower when storing it inside. If you don’t have any choice but to store your mower outdoors, you need to cover it with a waterproof covering like these marine grade coverings from Amazon.